From the Sea to the Sun

Molten Salt Waste Reactor: Burning What We Left Behind

Nuclear Waste Management RGB

Every conventional nuclear plant leaves behind spent fuel that still holds most of its energy, along with elements that stay dangerous for tens of thousands of years. Today we pack it into casks and pools and hand the problem to people who haven't been born yet.

A molten salt waste reactor asks a steward's question: what if that material did one more job first? Recycled into a liquid salt and burned in a reactor built for it, the longest-lived parts of nuclear waste could be turned into heat and electricity, leaving behind a smaller residue that fades in centuries rather than hundreds of millennia. This page sets out how that works, where the world stands, and the hard questions that still have to be answered.

Fuel
Dissolved in a liquid salt, not packed in solid rods
Operating pressure
Near atmospheric
First proven
Oak Ridge Molten-Salt Reactor Experiment, 1965 to 1969
Running today
China's 2 MW TMSR-LF1, refuelled while operating
The goal
Burn the long-lived elements in spent fuel

The problem

Energy left on the table

Solid-fuel reactors stop using their fuel long before its energy is spent. The used rods that come out contain three broad groups of material, and each poses a very different problem.

Most of the mass

Uranium

The bulk of spent fuel is still uranium, mildly radioactive and, in principle, reusable.

The long-term problem

Transuranics

Plutonium and the minor actinides are a small share of the mass but drive the hazard for tens of thousands of years. They are also fissile or fissionable, which makes them a fuel as much as a waste.

The short-term problem

Fission products

The fragments of split atoms are intensely radioactive at first but mostly decay within a few centuries. They still need safe isolation, just for far less time.

Spent nuclear fuel held in dry storage casks
Spent fuel waiting in dry storage casks: the material a waste-burning reactor aims to put back to work. Photo: U.S. Nuclear Regulatory Commission, not copyrighted, via Wikimedia Commons.

Burn the transuranics, and the timescale of the waste problem shrinks from geological to historical. That is the whole promise in one sentence.

How it works

A reactor with liquid fuel

In a molten salt reactor, the fuel is dissolved in a salt heated until it flows like water. The liquid either circulates through the core or, in some designs, sits sealed in tubes surrounded by a separate coolant salt. That one change, solid to liquid, reshapes almost everything else.

Safety

No high pressure

Salts stay liquid at high temperature without being pressurised, so there is no steam-pressure explosion to contain and far less driving radioactive material outward if something fails.

Safety

Fail by draining

Many designs include a passive drain: if the reactor overheats or loses power, the fuel salt flows by gravity into tanks shaped to keep it from sustaining a reaction, where it cools and solidifies.

Fuel

Refuel while running

New fuel can be added to the liquid without shutting down, and gaseous fission products can be removed as they form instead of building up inside sealed rods.

Heat

Hot enough for industry

Molten salt reactors run at around 650 °C or more, hot enough for efficient power generation, industrial process heat, hydrogen production and desalination.

Waste burning

Fast neutrons

To destroy transuranics efficiently, waste-burning designs typically use a fast neutron spectrum, which splits these heavy elements rather than merely breeding more of them.

Storage

Salt holds heat

The same kind of salt can store heat in tanks, letting a plant run steadily while sending out more power when the grid needs it most.

From waste to fuel

The closed loop

A waste-burning reactor can't simply be fed spent fuel rods. The waste first has to be recycled into a salt the reactor can use. Together, the two steps form a closed fuel cycle.

Step 1

Spent fuel

Used fuel from today's reactors, currently stored in pools and dry casks.

Step 2

Recycle to salt

A chemical process separates the transuranics, concentrating them into a fuel salt and removing most fission products.

Step 3

Burn

The reactor fissions the long-lived elements, releasing their energy as heat for power and storage.

Step 4

Isolate the rest

Shorter-lived residues are locked into durable solid forms such as glass and ceramic for safe storage.

The best-developed example of this pairing comes from Canada. Moltex Energy's Waste to Stable Salt process, known as WATSS, converts used oxide fuel into molten salt fuel in a single chemical process of about a day, and in 2025 it was validated on real used fuel bundles from a commercial CANDU reactor in hot-cell experiments at Canadian Nuclear Laboratories, extracting about 90% of the transuranic material in 24 hours. It was designed to feed the Stable Salt Reactor-Wasteburner, a fast reactor that keeps its fuel salt sealed in stationary tubes inside an unpressurised pool of coolant salt, rather than pumping radioactive fuel through pipes and valves.

Waste is only waste once we stop looking for its next use.The stewardship case for burning what we left behind

Where the world stands

The field in 2026

Molten salt reactors are older than most people realise, and newer than their promoters sometimes admit. Here is an honest snapshot.

Top-down view of the Molten-Salt Reactor Experiment at Oak Ridge National Laboratory
Looking down on the Molten-Salt Reactor Experiment at Oak Ridge, the reactor that proved liquid fuel works. Photo: Oak Ridge National Laboratory, public domain (US government work), via Wikimedia Commons.
1965 to 1969

Oak Ridge proves the idea

The Molten-Salt Reactor Experiment at Oak Ridge National Laboratory in Tennessee ran successfully for years, proving liquid-fuel operation. Funding then moved to other designs, and the approach sat largely dormant for decades.

Operating

China's thorium reactor

The 2 MW TMSR-LF1 in Wuwei, Gansu, was licensed to operate in June 2023, had thorium added in October 2024, and has since reported converting thorium into uranium fuel. Built on Oak Ridge's published designs, it is currently the world's leading operating molten salt reactor, though a research unit rather than a waste burner.

Permitted

The first US licence

In September 2024 the US Nuclear Regulatory Commission granted Abilene Christian University a construction permit for the 1 MW Natura MSR-1, the first liquid salt-fuelled reactor ever licensed by the NRC. It still needs an operating licence before it can be fuelled.

Changing hands

The waste burner's next chapter

Despite its technical progress, Moltex Energy entered administration. In August 2026, Nuclea Energy agreed to acquire its reactor and recycling technology, including WATSS and the waste-burning reactor design, pending a UK national security review.

A cautionary tale

Claims must survive checking

An earlier start-up, Transatomic Power, drew wide attention for a reactor said to run on spent fuel. In 2016 it found errors in its own analysis and withdrew the waste-burning claim, and it closed in 2018. Its honesty in correcting the record is part of the lesson.

In development

Others in the field

Chloride-salt fast reactors designed to run on recycled spent fuel and plutonium have been studied with US national laboratory support, and Russia has drafted a molten salt research reactor aimed at burning minor actinides.

Honest questions

What still has to be proven

We hold this technology to the same standard as everything else on this site: if it can't answer these plainly, it isn't ready.

  1. Materials. Hot salts are corrosive. Can vessels, pipes and heat exchangers last decades under heat, radiation and chemistry at once?
  2. Safeguards. Recycling separates elements that could, in the wrong hands, be misused. Is the process designed so that weapons-usable material is never isolated, and is every gram accounted for?
  3. Secondary waste. Used salts, off-gases, filters and structural materials are waste streams of their own. Is the total burden truly smaller, not just different?
  4. What remains. Fission products still need isolation for centuries. Is there a durable, monitored home for them from day one?
  5. Cost and time. Can the recycling plant and reactor be built and licensed in time, and at a price, to matter for the climate?
  6. Consent. Do the communities that host these facilities, including Indigenous nations, have a real say and a real share of the benefit?

Where Soterium fits

Closing the loop

We are not building nuclear reactors. Our role is to study, explain and connect: to follow the field honestly, and to look for the places where our own ideas can make a closed fuel cycle cleaner and safer.

What remains

Vitrifying the residue

The fission products left after burning are exactly what our epitaxial vitrification research aims to lock into stable, durable solids.

Biology

Life that thrives on radiation

Our work on radiotrophic fungi and Cladosporium sphaerospermum explores living shielding and monitoring around stored materials.

Heat

Storing the warmth

High-temperature salt heat pairs naturally with our thermal flywheel storage, letting steady reactor output follow the grid's needs.

Industry

Heat beyond electricity

Process heat for manufacturing, hydrogen and desalinated water extends the value of every unit of waste burned.

Keep exploring

Nuclear Waste Management

Further reading